日本語�j ENGLISH 中文

Ancillary equipment

Main type: HW3:Pressure switch
               HW1:Pressure switch
               HS3:High-pressure stop valve
               PG:Stop valve for pressure gauge
               PC:Pressure checker
               HAB3:Air bleed valve
               HA3:Air bleed valve
Pressure switch
HW3, HW1

FEATURES
  1. The pressure switch is designed to be compact and light.
  2. The pressure switch can be installed easily since drain piping is not necessary.
  3. The switch operating status (ON / OFF) can be confirmed through the operation check window.
PDF277kb

High-pressure stop valve
HS3

FEATURES

The high-pressure stop valve is used to allow or stop hydraulic fluid flow in the main circuit.

PDF129kb

Stop valve for pressure gauge
PG-SA, PG-S, PG-SB, PG-SC

FEATURES

The stop valve allows through or shuts off the hydraulic fluid flow to the pressure gauge.

PDF150kb

Pressure checker
PC

FEATURES

The pressure checker is used to allow through or shut off the hydraulic fluid flow to the pressure gauge. When the pressure checker is used, one pressure gauge can check the pressure for up to six circuits. In addition, since pressure is applied to the pressure gauge only during measurement, the pressure gauge can be protected from damage and its life prolonged.

PDF187kb

Air bleed valve
HAB3, HA3

FEATURES

The air bleed valve is installed at the discharge side of a pump or the actuator side to allow air to automatically escape from the circuit.

PDF091kb

Copyright j\ 2017 TOYOOKI KOGYO CO.,LTD. All Rights Reserved